Toshiba TDP-MT700 - Manual (Page 33)

Additional information 33
English
Troubleshooting
Problem Cause Remedy
The
projector
does not
turn on.
There is no power from the
power cord. Plug the power cord into the AC inlet
on the rear of the projector, and plug
the power cord into to the power outlet.
If the power outlet has a switch, make
sure that it is switched on.
The power switch is not in the
on position. Put the power switch in the on position.
Attempting to turn the projector
on again during the cooling pro-
cess. Wait until the cooling down process has
completed.
The lamp cover is not securely
attached. Correctly attach the lamp cover.
No picture.
The video source is not turned
on or connected correctly. Turn the video source on and check
that the signal cable is connected cor-
rectly.
The projector is not correctly
connected to the input source
device. Check the connection.
The input signal has not been
correctly selected. Select the correct input signal with the
INPUT buttons on the remote control or
INPUT on the projector.
Image is
unstable.
The connection cables are not
securely connected to the pro-
jector or the signal source. Correctly connect the cables to the
appropriate terminals.
Picture is
blurred.
The projection lens is not cor-
rectly focused. Adjust the focus of the lens using the
focus ring.
The projector and the screen
are not aligned properly. Adjust the projection angle and direc-
tion as well as the height of this unit if
necessary.
The lens cap is still attached to
the lens Remove the lens cap.
Remote
control does
not work
correctly
The batteries are out of power. Replace both of the batteries with new
ones.
There is an obstacle between
the remote control and the pro-
jector. Remove the obstacle.
You are too far away from the
projector. Stand within 8 meters (26.2 feet) of the
projector.
p. 20
p. 20
p. 30
p. 18
p. 18
p. 20
p. 18
p. 21
p. 21
p. 20
p. 11
p. 13
p. 13