Telular CDMA 2000 1X - Manual (Page 9)

Phonecell ® SX4P 1x 5 User Manual
Service Indication
Full Service
When it is powered on, the SX4P will display “Initializing” while it
sets up, then it will display your phone number followed by the
hardware and software versions. If service is available, “Telular
SX4 1x” will display when the setup is complete. If the unit is
roaming, an “R” will also display. Vertical indicator bars next to
the antenna icon display the signal strength (6 bars indicates a
full signal).
No Service
If no service is available, “No Service” will display when the SX4P
setup is complete. The antenna icon will still display, but no
indicator bars will display.
Making Calls
1. Pick up the handset, or press the Redial/Hands-Free key.
The SX4P is now “off-hook.”
2. When the dial tone sounds, dial the desired phone number. The dialed digits will display.
NOTE: The SX4P does not have speakerphone capabilities. The Redial/Hands-Free key allows
for hands-free dialing, but the handset must be used for actual conversation because there is no
external microphone on the SX4P.
Receiving Calls
When there is an incoming call, the SX4P will ring and display
caller ID information if it has been enabled. When the ringer is off,
caller ID information will still display. Contact your service provider
to activate caller ID.
1. Pick up the handset.
2. Begin talking.
Ending Calls
To end a call, place the handset back onto the SX4P cradle.
When a call is ended, the length of the call (in minutes and sec-
onds) will display.
Muting Calls
While in an active call, press the Voicemail key to mute the
microphone. To un-mute the call, press the Voicemail key. As
long as a call is muted, the screen will display “Mute” in the
lower right corner.
Full Service.
No Service.
Ending Calls.
Muting Calls.
Receiving Calls.