Telular CDMA 2000 1X - Manual (Page 5)

Phonecell ® SX4P 1x 1 User Manual
SX4P SETUP
Emergency Batteries
Install Batteries
1. Remove the battery access door screw that is located on the bottom of the unit - see
Figure 1.
2. Press the battery access door tab and remove the battery access door.
3. Install 6 “AAA” alkaline batteries (not supplied).
4. Reattach the battery access door and replace the battery access door screw.
Battery Operation
The SX4P will not switch automatically from AC to battery power when AC power is lost. The
AC/Battery switch must be set to the battery position manually - see Figure 2. Battery power will
provide up to 1 hour of talk time and 48 hours of standby time.
Location and Setup
The SX4P comes with a standard spike antenna (TNC).
1. Attach and finger-tighten the antenna. Do not over-tighten the antenna - see Figure 3.
2. Select a location that is above ground and close to windows or exterior walls to get the best
signal - see Figure 4.
Battery Access
Door Screw
Battery Access
Door Tab
Battery Access
Door
6 AAA Batteries
Figure 3 - Attach the antenna. Figure 4 - SX4P location.
Battery Position
AC Position
Figure 1 - Battery installation. Figure 2 - AC/battery switch.