Toshiba IK-HR1S - Manual (Page 26)

26
Items to be checked Symptom
No picture 䍃 Is power supplied correctly?
䍃 Is the lens iris adjusted correctly?
䍃 Are the camera and video cables connected correctly?
䍃 Is the shutter mode set correctly?
䍃 Is the monitor on, and in working condition?
䍃 Can the monitor (that you are using) accept the HD-SDI signal coming out of the
camera?
Poor color 䍃 Is the monitor adjusted correctly?
䍃 Is the white balance of the camera adjusted correctly?
(in modes other than automatic tracking)
䍃 Is the matrix color correction set correctly?
䍃 Is the illumination sufficient?
8. BEFORE MAKING SERVICE CALL
Power supply 12V DC 㫧10%
Power consumption Approx. 3.5 W
Image sensor 1/3 inch color CMOS sensor (Rolling shutter)
Output pixels Horizontal : 1920, Vertical : 1080 (max)
Scanning system Progressive
Signal system 1080/59.94i, 1080/50i, 720/59.94p, 720/50p
Scan frequency Horizontal : 33.716 kHz, Vertical : 59.94 Hz (1080/59.94i setting)
Horizontal : 28.125 kHz, Vertical : 50 Hz (1080/50i setting)
Horizontal : 44.955 kHz, Vertical : 59.94 Hz (720/59.94p setting)
Horizontal : 37.500 kHz, Vertical : 50 Hz (720/50p setting)
Sync system Internal
Sensitivity F 4 standard (2000 lx, 3000K)
Minimum illumination
8 lx standard (50 IRE, F1.4, gain 㧗18 dB,
gamma setting ON (setting value 0), 3000 K)
Lens mount C mount
Operating temperature (32 㫦 㫦F) to 40 0 F to 104 㷄 㷄
Operating humidity Less than 90% (non condensing)
Weight Approx. 150 g (0.33 lbs)
External dimension 44(W) × 44(H) × 78(D) mm (1.73”(W) 㬍㩷1.73”(H) 㬍㩷3.07”(D) ) (excluding protrusions)
Scene file A, B, C, D, E
White balance
ATW 䋨Automatic tracing white balance䋩, AWB䋨Automatic white balance䋩,
MANUAL 䋨Manual䋩
Gain MANUAL (Manual), OFF (0 dB)
Output signal HD-SDI (SMPTE292M), 0.8 V (p-p) standard
75 ohms unbalanced BNC connector
Remote control Serial data interface (RS-232C)
Design and specifications are subject to change without notice.
9. SPECIFICATIONS