beautypg.com

1 rca/optical jumpers, 2 switches, 3 led indicators – Texas Instruments TAS5727 User Manual

Page 13

background image

www.ti.com

Jumpers and Control Utilities on MC57xxPSIA board

4

Jumpers and Control Utilities on MC57xxPSIA board

4.1

RCA/OPTICAL Jumpers

Select the jumper to reflect the source whether it is RCA or OPTICAL.

4.2

Switches

JP1 on the daughter card is for PBTL select. Jumper IN means non-PBTL mode. For PBTL, remove this
jumper.

Reset is an active-low function. Pressing the master reset switch (S2) resets the TAS5727 device; USB
RESET (S1) resets the USB bus. Pressing PDNZ (S4) powers down the TAS5727, and pressing MUTE
(S5) mutes (volume mute) the TAS5727.

4.3

LED Indicators

LED1 : USB Power connector installed at J1

LED2 : 3.3V Power is valid

LED3: RCA connection made

LED4: Optical connection made

LED5: SPDIF signal locked

LED6: FAULT (This LED should be ignored until FAULT is programmed to be an output via I

2

C write

to reg 0X05.)

LED7: PDN switch (S4) is pressed (closed)

13

SLOU299

December 2010

TAS5727 25W Digital Input Amplifier

with EQ and 2-Band DRC

Submit Documentation Feedback

Copyright

©

2010, Texas Instruments Incorporated