Texas Instruments TAS5727 - Manual (Page 12)

Using the EVM Software www.ti.com
3.5.1 MODULATION SCHEMES
Using The FAULT PIN As An Error Indicator:
The A_SEL_FAULTZ pin is the I 2 C device address select by default. To re-define this pin as an output,
write '1' to bit D1 of reg 0X05. Once re-programmed as output, this pin indicates a fault condition. Output
will go low for Overcurrent (OC) or undervoltage (UVP) error or overtemperature error (OTE) or
overvoltage error
Common Configurations:
1. 2 × BTL BD Mode
2. 2 × BTL AD Mode
Note:
AD: AD Modulation-Outputs are 180 ° out of phase
BD: BD Modulation
BTL: Bridge-Tied Load
3.5.1.1 2 X BTL BD (BD mode)
1. Set up the hardware.
2. Select the Input MUX from GDE. In the Properties window, select BD Mode.
3. GDE: Target > Connect.
4. Finally uncheck the shutdown box to bring the device out of Shutdown mode, and adjust the Master
Volume as desired.
3.5.1.2 2 X BTL AD (Default: AD mode)
1. Set up the hardware.
2. Select the Input MUX from GDE. In the Properties window, select AD Mode.
3. GDE: Target > Connect.
4. Finally uncheck the shutdown box to bring the device out of Shutdown mode, and adjust the Master
Volume as desired.
12 TAS5727 25W Digital Input Amplifier — with EQ and 2-Band DRC SLOU299 – December 2010
Submit Documentation Feedback
Copyright © 2010, Texas Instruments Incorporated