TRENDnet TW100-BRF114U User Manual

Page 62

Broadband Router User Guide

Data - Special Applications Screen

Checkbox

Use this to Enable or Disable this Special Application as required.

Name

Enter a descriptive name to identify this Special Application.

Incoming
Ports

• Type - Select the protocol (TCP or UDP) used when you receive data

from the special application or service. (Note: Some applications use
different protocols for outgoing and incoming data).

• Start - Enter the beginning of the range of port numbers used by the

application server, for data you receive. If the application uses a single
port number, enter it in both the "Start" and "Finish" fields.

• Finish - Enter the end of the range of port numbers used by the applica-

tion server, for data you receive.

Outgoing
Ports

• Type - Select the protocol (TCP or UDP) used when you send data to

the remote system or service.

• Start - Enter the beginning of the range of port numbers used by the

application server, for data you send to it. If the application uses a sin-
gle port number, enter it in both the "Start" and "Finish" fields.

• Finish - Enter the end of the range of port numbers used by the applica-

tion server, for data you send to it. If the application uses a single port
number, enter it in both the "Start" and "Finish" fields.

Using a Special Application

• Configure the Special Applications screen as required.
• On your PC, use the application normally. Remember that only one (1) PC can use each

Special application at any time. Also, when 1 PC is finished using a particular Special Ap-
plication, there may need to be a "Time-out" before another PC can use the same Special
Application. The "Time-out" period may be up to 3 minutes.

If an application still cannot function correctly,
try using the "DMZ" feature.

Multi-DMZ

This feature, if enabled, allows one (1) or more computers on your LAN to be exposed to all
users on the Internet (if you only have 1 WAN IP addresses, only DMZ 1 can be used), allow-
ing unrestricted 2-way communication between the "DMZ PC" and other Internet users or
Servers.
• This allows almost any application to be used on the "DMZ PC".
• The "DMZ PC" will receive all "Unknown" connections and data.
• If the DMZ feature is enabled, you must select the PC to be used as the "DMZ PC".
• The DMZ feature can be Enabled and Disabled on the Advanced Internet screen.