Toshiba Qosmio Personal Computer X500 - Manual (Page 213)

Replacement Procedures
4.19 CPU
Removing the CPU heat sink
The following describes the procedure for removing the CPU heat sink (See Figure 4-19-1 to
4-19-2).
1. Disconnect the Heat sink cable from the connector on the system board
2. Remove the following screws securing the heat sink holder along 1 to 4.
 M22 SPRING screw x4
NOTE: When removing the heat sink holder, be sure to remove the screws in the reverse
order of the number marked on the holder.
3. Remove the CPU heat sink.
Figure 4-19-1 Remove the CPU heat sink
Qosmio X500 Maintenance Manual (960-Q08)
54