Teac SR-L280i - Manual (Page 35)

35
EN
GL
IS
H
If you have problems with your system, look through this
chart and see if you can solve the problem yourself before
calling your dealer or TEAC service center.
General
No power
e Check the connection to the AC power supply. Check
and make sure the AC source is not a switched outlet
and that, if it is, the switch is turned on. Make sure
there is power to the AC outlet by plugging another
item such as a lamp or fan into the outlet.
No sound from speakers.
e Select the source by pressing the FUNCTION button.
e Adjust the volume.
e If the MUTING indicator blinks on the display, press the
MUTING button.
The sound is noisy.
e The unit is too close to a TV or similar appliances.
Install the unit apart from them, or turn them off.
Remote control unit does not work.
e If the battery is exhausted, replace it with a new one
(see page 14).
e Use remote control unit within the range (5 m) and
point at the remote sensor on the front panel.
e Clear obstacles between the remote control unit and
the main unit.
e If a strong light is near the unit, turn it off.
CD Player
Cannot play.
e Load a disc with the label side up.
e If the disc is dirty, clean the surface of the disc.
e A blank disc has been loaded. Load a prerecorded
disc.
e Depending on the disc, etc. it may not be possible to
play back CD-R/RW discs. Try again with another disc.
e You cannot play back unfinalized CD-R/RW discs.
Finalize such a disc in a CD recorder and try again.
Sound skips.
e Place the unit on a stable place to avoid vibration and
shock.
e Do not use scratched, damaged or warped discs.
Troubleshooting
iPod Player
Cannot insert the iPod.
e Check the dock adapter (see page 13).
e Remove dust or obstacles from the Dock connector of
this unit and the iPod, and insert the iPod again.
Will not play.
e Remove the iPod from the dock, wait a few seconds,
and insert it again.
e Software update may solve the problem. Visit the
Apple website and download the latest iPod Software
(see page 13).
Cannot operate the iPod.
e Set off the HOLD switch of the iPod.
Tuner
Cannot listen to any station, or signal is too weak.
e Tune in the station properly.
e Rotate the FM or the AM antenna until you get stations
clearly.
If normal operation cannot be recovered, unplug the
power cord from the outlet and plug it again.