Quick Eagle Networks DL3800E - Manual (Page 25)

Quick Install Guide 1-3
1
Network Configuration
Set up a port for each E1 line you plan to use. Set Alarm to Report. Set
ACTICVE/RESTORE MODE
to Use w/auto restore. Normally is CRC4
enable. Primary clock Xmt=Network (assuming carrier or remote unit
providing timing). Primary clock RCV should be set to AUTO. Configure
SER to Immediate Confirm and select EXIT. Select Exit again to the Main
Menu.
Save Configuration
Select SAVE CONFIGURATION from the Main Menu.
You’re done! If you have any questions, please feel free to call Quick Eagle
Network’s Technical Support at (408) 745-4200.