QHT Boiler - Manual (Page 16)

Separate Vent Kit Installation Cont.
Figure 5
Figure 6
Elbow Installation : Figure 6
• Install the exhaust elbow (F) onto the
exhaust collar (J).
• Install the intake elbow (F) onto the intake
collar (I).
• Slide each termination (intake & exhaust)
into the corresponding elbow.
• Slide the external wall gaskets onto the
terminations until they are seated against
the building.
16
Intake Installation :
Remove the intake cover plate. Install the
intake gasket over the intake hole. Mount the
intake collar (I) with the 4 screws (G) supplied,
as shown in figure 5.