Quatech DSP-100 - Manual (Page 27)

4. Windows 98/Millennium (ME) Installation
To allow easy configuration of the DSP-100, an Windows 98/ME "INF" configuration
file has been written for the hardware. This configuration file supports the DSP-100 in
both addressing modes: block mode and “com” mode.
4.1 Installing a DSP-100 Under Windows 98/ME.
1. Insert the DSP-100 into any available PC Card socket.
2. The first time a new PC Card type is installed the New Hardware Found
window opens. After this first installation Windows 98/ME will
automatically detect and configure the card. If the New Hardware Found
window does not open, then skip to the next section, “DSP-100 Resource
Settings".
3. The New Hardware Found window provides several options to configure
the DSP-100 card. Click the "Driver from Disk" option button. Click "OK"
to continue.
4. An "Install from Disk" dialog box should appear. Insert the diskette with
the "DSP-100.INF" file, select the correct drive letter and path, and click
"OK". Windows 95 will browse the path for the aforementioned files.
5. During the installation process, it may be required to supply the computer
with the Windows 98/ME CD or installation diskettes. The DSP-100's serial
devices will require the file "SERIALUI.DLL". Insert the CD or diskette
and click "OK".
IMPORTANT NOTE:
If the user already has these files installed on the
computer, or if the installation disks are unavailable, it
may not be necessary to supply the computer with the
Windows 98/ME CD or installation diskettes. If
prompted for the disks, click “OK”. A dialog box with an
option to skip will appear. Click the “Skip” button and
the files will not be installed. If these files exist in the
windows system directory, those files will be used.
The DSP-100 PC Card should now be configured. In the future, Windows 98/ME will
automatically recognize and configure the DSP-100.
DSP-100 User's Manual 21