Quatech DSP-100 - Manual (Page 19)

2.2.1.4 Example 4
DSP100EN.EXE (s0,b300,i3,wd8)
In example 4, the Enabler will configure the DSP-100 in socket 0 with a base address of
300H and IRQ 3 using a configuration memory window at segment D800. The
DSP-100's interrupt status register will be enabled.
2.2.1.5 Example 5
DSP100EN.EXE (s0,b300,i5,r)
In example 5, the Enabler will release the configuration used by the DSP-100 in socket 0
using a configuration memory window at segment D000. The base address and IRQ
parameters are ignored and may be omitted.
2.2.1.6 Example 6
DSP100EN.EXE (s1,r,wcc)
In example 5, the Enabler will release the configuration used by the DSP-100 in socket 1
using a configuration memory window at segment CC00.
DSP-100 User's Manual 13