Displays (see, Figure 11 – Quantum Audio Tape Drive Scalar 50 User Manual
Page 12
Quantum Scalar 50 Tape Drive Installation Instructions
Document 81-81769-01 B01
September 2007
12
Setting the Tape Drive SCSI ID
Figure 11 Host Bus
Options Screen
4
Use the up and down arrows to highlight the tape drive receiving the new
SCSI ID and press
Enter
.
5
Use the up and down arrows to select a SCSI ID and press
Enter
to set the
ID.
6
When you have completed setting the SCSI IDs, press
Exit
to return to the
Cabinet
screen.
7
From the
Ops
screen, use the up and down arrows to highlight
Drive
Operations
and press
Enter
.
The
Drive Operations
screen displays (see
):
Figure 12 Drive
Operations Screen
8
Use the up and down arrows to select a tape drive and press
Enter
.
9
Use the up and down arrows to select
Off
and press
Enter
.
The tape drive powers down and returns to the
Drive Operations
screen.
10
Use the up and down arrows to select
On
and press
Enter
.
The tape drive powers on and is ready for use. The tape drive installation
is complete.
Setting the SCSI ID
from the Remote
Management Pages
0
To set the tape drive SCSI ID on a Scalar 50 Series library from the remote
management pages:
1
On the host computer, open the internet browser software.
2
In the
Address
field, type http://IPaddress/ where IP address is the IP
address for the Quantum Scalar 50 Series library.
Note:
The library must be off-line during this procedure.