Input/output assign, En-57 – Onkyo AV Receiver TX-NR818 User Manual
Page 57
Advanced Operations
En-57
Main Menu
Input/Output Assign
Monitor Out
On the “Monitor Out” settings, you can select whether or
not to have the video sources’ images output through the
HDMI output.
If you connect your TV to the HDMI output, the “Monitor
Out” setting is automatically set and composite video and
component video sources are upconverted
*
and output.
Note
• See “Video Connection Formats” (
) for charts
showing how the “Monitor Out” and “Resolution” settings
affect the video signal flow through the AV receiver.
■
Monitor Out
`
Main:
Select this if your TV is connected to HDMI OUT
MAIN.
`
Sub:
Select this if your TV is connected to HDMI OUT
SUB.
`
Both:
Select this if your TVs are connected to HDMI OUT
MAIN and HDMI OUT SUB. Video signals are
output from both HDMI outputs at the resolution
supported by both TVs.
Changing the “Monitor Out” setting manually
■
Resolution
`
Through:
Select this to pass video through the AV receiver at
the same resolution and with no conversion.
`
Auto:
Select this to have the AV receiver automatically
convert video at resolutions supported by your TV.
`
480p (480p/576p), 720p, 1080i, 1080p:
Select the desired output resolution.
`
1080p/24:
Select this for 1080p output at 24 frames per second.
`
4K Upscaling:
Select this for an output resolution four times that of
1080p. Depending on the resolution supported by
your TV, it will result in either 3840 × 2160 or 4096
× 2160 pixels.
`
Source:
Select this for an output following the resolution level
set in “Picture Adjust” (
You can specify the output resolution for HDMI OUT
MAIN and have the AV receiver upconvert the picture
resolution as necessary to match the resolution supported
by your TV.
Tip
• You can see the picture by pressing ENTER to check the
“Resolution” setting (excluding NET input source).
Note
• Depending on the incoming video signal, the video playback may
not be smooth or the vertical resolution may be lowered. In this
case select anything other than “1080p/24”.
• With some TVs, there may be no picture when this setting is set
to “4K Upscaling”.
• If the “Monitor Out” setting is set to “Sub”, this setting is fixed
to “Through”.
• If the “Monitor Out” setting is set to “Both”, this setting is fixed
to “Auto”.
Input/Output Assign
1 2 3 4
5
“Setup”
IN
OUT
Composite video,
component video
HDMI
HDMI
Composite video,
component video
1
Press
MONITOR OUT on the front panel.
The current setting is displayed.
2
Press
MONITOR OUT on the AV receiver
repeatedly to select:
`
HDMI Main, HDMI Sub or Both.