Olympus SZ-30MR - Manual (Page 27)

27 EN
Submenu Application
Auto
Panorama images are automatically
combined just by swinging the camera in
the shooting direction. Press the shutter
button once to begin the sequence.
Manual
Three frames are taken and combined
by the camera. The user composes
the shots using the guide frame and
manually releases the shutter.
PC
The frames that were taken are
combined into a panorama image using
the PC software.
3
When shooting with [Auto]
Use HI to select the angle of view and then
press the A button.
For details on installing the PC software, see
“Charging the battery and setting up using the
supplied CD” (p. 13).
When set to [Auto] or [Manual], [Image Size]
(p. 40) is fi xed to 2M or equivalent.
The focus, exposure, zoom position (p. 20), and white
balance (p. 34) are locked at the fi rst frame.
The fl ash (p. 32) is fi xed to $ (Flash Off) mode.
To shoot with [Auto] To shoot with [Auto]
1 Point the camera to the start position.
Use FGHI to select the shooting direction.
2 Press the shutter button to begin shooting. Move
the camera slowly in the arrow-marked direction that
shown on the monitor.
MENU Cancel OK Save
AUTO
FULL
Guide
●
3 When shooting reaches the end of the guide on the
monitor, it fi nishes automatically.
The camera automatically processes the images
and the combined panorama image is displayed.
To stop shooting in the middle, press the shutter
button or
A button. If the camera pauses for a
while, shooting automatically fi nishes.
If the message “Image was not created.” is displayed,
shoot again.
To exit the panorama function without saving an
image, press the m button.
Taking pictures with [Manual] Taking pictures with [Manual]
1 Use FGHI to specify at which edge the next
picture is to be connected.
Direction for
combining the next
frame
OK Set
MANUAL MANUAL
2 Press the shutter button to take the fi rst frame. The
white-boxed part of the fi rst frame is displayed on joint
area 1.
1st frame
1 2 1 2
MENU OK Save Cancel
MANUAL MANUAL MANUAL MANUAL
3 Compose the next shot so that joint area 1 overlaps
joint area 2.
4 Press the shutter button to take the next shot.
Press the A button to combine just 2 frames.
●
●