Oricom W1 - Manual (Page 17)

17
3. Before you enter the PIN, press and hold on the base for 2
seconds until a registration tone is emitted. The base is now in the
registration mode. (If the base is full and cannot take on any more
handset, it will emit a reject tone instead. See the section of
Deregister to delete a currently registered handset.)
4. Enter the PIN of the base and press OK .
You will hear a confirmation tone if the registration is successful. The
handset label and the handset number will be displayed.
If the registration is not successful, you will see NOT REG on the
handset. Follow the procedure and try again.
Deregister
A handset can deregister another handset registered to the same base.
It cannot deregister itself.
1. Press
PROG during standby follow by the 9 key.
2. Enter the handset number (i.e. HS#2) to delete. The LCD will display
9-2.
3. Press OK and then
4. Enter the PIN
5. Press
OK to confirm.
PIN code
A PIN is required for registration and deregistration. The ex-factory PIN
is 0000 but you can change this code.
1. Press
PROG during standby follow by the 8 key.
2. Enter the current PIN and press OK .
3. Enter the new PIN. It can contain from 0 up to 8 digits. Press OK .
4. Repeat the new PIN and press OK to confirm the new code. You
will hear a confirmation tone if it is successful, or a reject tone if the
same PIN is not entered.
Reset
If you reset the phone, all the settings will return to the factory default
settings.
1. Press
PROG during standby. Then press and hold MUTE until
RESET is displayed.
2. Press OK to confirm the action.
You cannot reset the phone if the handset has lost link with the base.
UNAVAIL will be displayed. Re-establish the link and try again.