Oricom W1 - Manual (Page 16)

16
6. Press OK to confirm your selection. will turn on if the handset
ringer is turned off.
Base Ringer Melody & volume
1. Press PROG during standby and press
e or f until you see
flashing.
2. Press OK to select.
3. Press e or f to listen to and select from the 5 melodies.
4. Press OK to confirm your selection and you will be prompted to
volume Setting.
5. Press e or f to listen to and select from the different volume
levels.
6. Press OK to confirm your selection.
You have the option to turn off the base ringer.
You cannot program the base ringer if the handset has lost link with the
base. UNAVAIL will be displayed. Re-establish the link and try again.
Recall duration
When you are talking on the phone, pressing will send a flash signal.
Recall settings are; Australia (Recall 1)100ms and New Zealand (Recall
2) 600ms. You should not need to change these settings.
.
1. Press PROG during standby and press
e or f until you see
flashing.
2. Press OK to select. The current duration is now displayed.
3. Press 1 or 2 directly or press
e
or
f
to select.
4. Press OK to confirm.
Register
Each handset can register to one base at a time only. The current base
will be deregistered when a new base is registered.
Each base can register up to 4 handsets.
1. Press
PROG during standby and press or until you see
icon flashing.
2. Press OK to select.