Oricom M2400 - Manual (Page 17)

Paging the handsets
You can page or locate the handsets by pressing on the base. All
handsets registered to the base will produce the paging tone for 30 seconds
and the screen displays blinking “oooo”.
You could stop the paging by pressing any key on each handset or pressing
on the base again.
Out of range warning
When you are talking on the phone and you take the handset too far away
from the base, you’ll hear an alert tone through the speaker. You should
bring the handset back in range with the base. Failing to do so will result in
the call being disconnected.
When the handset is too far away from the base during standby, you will see
flashing.
MULTI-HANDSET OPERATION
You have additional features if you have up to more than one handset
registered to the base.
Making an internal call
When the phone is in standby,
1. Press
INT . turns on and you’ll hear an internal dialing tone.
2. Press the number of the handset that you want to call.
(Or you can press the handset number first, followed by
INT .)
You will hear a busy tone if the other handset is not available.
To end an internal call, press
or place handset on cradle.
Answering an internal call
When you receive an intercom call, your handset will ring with blinking.
You can see the calling handset number on the screen.
If you press
when the phone is ringing, the handset ringer will be
turned off for this incoming internal call.
Press
to answer.
You will be alerted with short beeps if you receive an external call during your
intercom. Caller information will be displayed if it is available. You need to
end the intercom first before you can answer the external call.
During an external call
Inquiry call
1. Press
INT to put the external line on hold.
2. Press the handset number that you want to call.
3. After the other handset has answered, you can press
INT repeatedly to
switch between the external line and the intercom.
If the other handset does not answer, press INT again to cancel the attempt
and return to the external line.
Call transfer
While you are on an inquiry call with the other handset, press
or place
handset on cradle. The call has now been transferred.
SEARCHNG
Conference call
While you are in an inquiry call with the other handset, press and hold
CONF
to set up a conference call between the external line and 2 handsets.
During the conference call, pressing
CONF will put the external line on hold
and you can talk to the other handset in private. Press and hold CONF to
establish the conference call again.
Any handset hangs up during a conference call will leave the other handset
still connecting with the external call.
DEFAULT SETTINGS
Default settings are as follow:
Handset ringer melody: 1
Handset ringer volume: Level 3
Base ringer melody: 1
Base ringer volume: Level 3
Key tone: On
Backlit: On
Recall duration: Duration 1
Receiver/speaker volume: High
Handset Keypad lock: Off
Message waiting indication: Off
17