Oricom M2400 - Manual (Page 10)

If when you are using network services or a PBX the button does not
work you can select a different setting.
1. In Settings menu, select RECALL and press
OK . The current duration
will be displayed.
2. Select RECALL 1 or RECALL 2 and press OK to confirm.
Register
Each handset can be registered to only one base at a time . The current
base will be deregistered when a new base is registered.
Each base can register up to 5 handsets.
1. In Settings menu, select REGISTER and press
OK .
2. Before you enter the PIN, press and hold key on the base for 4
seconds until a registration tone is emitted. The base is now in the
registration mode. (If the base is full and cannot take on any more
handset, it will emit a reject tone instead. See the section of Deregister
to delete a currently registered handset.)
3. Enter the PIN of the base and press OK
You will hear a confirmation tone if the registration is successful. The
handset label and the handset number will be displayed.
If the registration is not successful, you will see NOT REG on the handset.
Follow the procedure and try again.
Deregister
A handset can deregister another handset registered to the same base. It
cannot deregister itself.
1. In Settings menu, select DEL HS and press
OK .
2. Press and to select the handset you would like to
deregister and press OK .
3. Enter the PIN and press OK to confirm.
PIN code
A PIN code is required for registration and deregistration. The factory set
PIN code is 0000 but you can change this code.
1. In Settings menu, select PIN CODE and press
OK to confirm.
2. Enter the current PIN and press OK .
3. Enter the new PIN. It can contain up to 8 digits. Press OK .
4. Repeat the new PIN and press OK to confirm the new code. You will
hear a confirmation tone if it is successful, or a reject tone if the same
PIN is not entered.
Reset
If you reset the phone, all the settings will return to the factory default
settings.
1. In Settings menu, press
and until RESET is displayed and
press OK .
2. Press OK again when you are prompted to confirm the action.
You cannot reset the phone if the handset has lost link with the base.
UNAVAIL will be displayed. Re-establish the link and try again.
.
10