Opticon LPR5627 User Manual

Page 26

Manual No. 25-ULPNR101-03; Feb, 2003 LPN5627 / LPR5627 Laser Fixed Mount

Scanner

Page 22

Volume = Minimum

Ring buzzer once at 3kHz for 200 mS

Ring buzzer at 3kHz & 2kHz for 200 mS

Ring buzzer at 2kHz & 3kHz for 200 mS

Disable Buzzer

Enable buzzer at 3kHz

Enable buzzer at 3kHz with 2.5kHz interval

Enable buzzer at 2kHz with 3kHz interval

Buzzer duration 0.10 sec

Buzzer duration 0.20 sec

Buzzer duration 0.40 sec

Buzzer duration 0.05 sec

Buzzer duration 0.01 sec

Positive & Negative Bar Codes

Positive bar codes only

Both positive and negative bar codes

Setting the Trigger Function

Disable the trigger function (Laser On)

Enable the trigger function (Laser OFF until
the trigger is activated )

Activate the trigger; turns the laser ON

Selecting the Read Mode

Single Read Mode (Trigger must be Enabled,
S8)

Multiple Read Mode

Continuous Read Mode

Does not allow first bar distortion

Allow first bar distortion

Normal scan

Scanner Timeout (Trigger Enabled Mode)

Laser remains ON as long as trigger is pulled
(hardware trigger only)

1 second after triggering

2 second after triggering

3 second after triggering

4 second after triggering

6 second after triggering

8 second after triggering

10 second after triggering

Redundant Decoding

Read bar code once

Read bar code twice before transmitting

Read bar code three times before transmitting

Read bar code four times before transmitting

Read bar code five times before transmitting

Read bar code six times before transmitting

Xmit Error (Trigger Enabled Mode only)

Do not Xmit error code

Xmit “BR” for bad read or no read

Xmit ”>” for bad read;
“?” for no read

Xmit “>” for bad read,”?” or no
read

Transmit “” for bad read or no
read

Xmit “” for bad read or no read

Print Quality Adjustment

For lower density, poor print (low gain)

For high density, good print quality bar code
without voids (high gain)

Xmit data from Low or High gain