Onkyo DX-R700 - Manual (Page 33)

33
Finalization
DUAL DIGITAL INPUT
ANDBY ST
OFF ON
STANDBY/ON
POWER
AUDIO CD RECORDER DX-R 700
MEMORY CLEAR
REPEAT FINALIZE
STOP PLAY PAUSE
REC
PHONES LEVEL
MIN MAX
PHONES
YES
INPUT DISPLAY
EDIT/ NO
PUSH TO ENTER
MULTI JOG
YES FINALIZE
After showing “Finalize,” the display shows, for
example, “Ok? -1m58s” together with the time
information.
Memo:
The DX-R700 will stop, if this state persists for
10 minutes or more.
3
After the time information appears,
press the YES button.
Finalization begins. During finalization, the
remaining time is displayed. (Finalization takes
approx. 2 minutes.)
FINALIZE
YES
When finalization finishes
The DX-R700 automatically stops.
To stop the finalization process
Press the e STOP button or the EDIT/NO button
(before pressing the YES button in step 3).
Display after finalization
For CD-Rs, the display becomes that for CDs. For
CD-RWs, the display does not change, except that
FINALIZE is added.
Notes:
• You cannot finalize your disc which may have an
artist name or track titles but no disc name on it.
With such a disc, “Name Disc” will appear when
you press the FINALIZE button. In this case, enter
a disc name before finalizing the disc (see page
28).
• Never turn off the power or remove the power
cord during finalization. Doing so may damage
all the data on the disc. An inserted disc can be
corrupt and no longer usable if the power is
accidentally turned off or in case of power
failure.
• Never finalize discs that are scratched, dirty, or
dusty. Doing so may prevent the process from
being properly completed. If the process does
not finish in 10 minutes, press the e STOP
button and abort the process. This disc will not
be able to be played with normal CD players.
• During finalization, the operation button on the
DX-R700 will be disabled.
Auto finalization
You can perform auto finalization during
synchronous recording by input signal detection (see
page 22). When auto finalization is turned on,
finalization occurs automatically at the end of
recording. For details, refer to the applicable pages.
FINALIZE
Finalization is a process of writing the TOC data
(track numbers etc.) and the name information
retained in the DX-R700 to the special area (PMA) of
the disc.
After finalization
CD-Rs can be played in CD players. Even after
finalization, CD-RWs can only be played on CD
players that are compatible with CD-RWs.
For finalized CD-Rs, you cannot add more recordings
and name information.
1
Insert the CD-R or CD-RW to be finalized
into the DX-R700.
2
Press the FINALIZE button.
Flashing