Onkyo K-505TX - Manual (Page 12)

12
Recording
4
Prepare the source component
you want to record from.
• Tuner
Tune into the station you want to record.
• CD player/MD recorder
Insert a CD (MD) into the CD player
(MD recorder).
• Cassette tape deck/DAT
Insert a recorded cassette into the
cassette tape deck or DAT.
5
Select the component you
prepared in the above step with
the input selector on the
amplifier.
6
Start playing the source you
prepared in step 4, for recording
adjustment.
7
Press to put the unit in
recording pause.
8
Press DOLBY NR until the Dolby
NR mode you want to record
with lights in the display.
See “Dolby Noise Reduction Systems” on
page 15 for Dolby NR mode information.
Each press changes the indicator in the
display in the following order:
Before starting
The shadowed steps are operations with the
other components.
1
Press STANDYBY/ON, if the unit
is not turned on.
2
Insert a cassette with its erasure
prevention tabs in place,
following step 1 in “Playing a
tape” on page 9.
See “Preventing an accidental recording”
on page 15.
3
Press REV. MODE to select the
reverse mode.
Each press changes the indicator in the
display;
or .
• When is lit
The unit records both sides of the tape
and stops.
Note
If you start recording on the reverse side of
the tape in step 11, the unit will record only
the reverse side and then stop, even if the
reverse mode is set to
.
• When is lit
The unit stops after recording one side
of the tape.
STANDBY/ON
REV. MODE
DOLBY NR
Display
STANDBY/ON
STANDBY
STEREO CASSETTE TAPE DECK
ALBUM
DOLBY NR
REV. MODE
COUNTER RESET
REC LEVEL
CD DUBBING
FADE
CASSETTE LOADING MECHANISM
STANDBY/ON
REV. MODE