Onkyo TX-DS595 - Manual (Page 5)

5
Installing the remote controller batteries
1. Remove the battery compartment cover by pressing
and sliding the cover.
2. Insert two AA (R6 or UM-3) batteries into the battery
compartment. Carefully follow the polarity diagram
(positive (+) and negative (–) symbols) inside the
battery compartment.
3. After batteries are installed and seated correctly,
replace the compartment cover.
Before using this unit
CAUTION:
6 OHMS
MIN.
/ SPEAKER
R L
REMOTE
CONTROL
FM 75
AM
ANTENNA
GND
SEE INSTRUCTION MANUAL
FOR CORRECT SETTING.
4 OHMS
MIN.
/ SPEAKER
FRONT SPEAKERS A CENTER SPEAKER SURROUND
SPEAKERS
FRONT SPEAKERS B
R L
R L
R L
L
R
VIDEO
IN OUT IN IN IN
L
R
CENTER
SUB WOOFER
FRONT SURR
SUBWOOFER
OPTICAL COAXIAL
1
2
1 2
PRE OUT MULTI CHANNEL INPUT DIGITAL INPUT
L
R
OUT IN PHONO TAPE CD
IMPEDANCE SELECTOR SET BEFORE POWER ON
S VIDEO
MONITOR OUT DVD VIDEO 3 VIDEO 2 VIDEO 1
AV RECEIVER MODEL NO. TX-DS595
120V VOLTAGE SELECTOR 220-230V
SWITCHED TOTAL 100W MAX.
AC OUTLETS
VOLTAGE
SELECTOR
120V
220-230V
Setting the Voltage selector
(Worldwide models only)
Worldwide models are equipped with a voltage selector to conform
with local power supplies. Be sure to set this switch to match the
voltage of the power supply in your area before plugging in the unit.
Determine the proper voltage for your area: 220-230 V or 120 V.
If the preset voltage is not correct for your area, insert a screwdriver
into the groove in the switch. Slide the switch all the way to the upper
(120 V) or to the lower (220-230 V), whichever is appropriate.
Notes:
• Do not mix new batteries with old batteries or different kinds of
batteries.
• To avoid corrosion, remove the batteries if the remote controller
is not to be used for a long time.
• Remove dead batteries immediately to avoid damage from
corrosion. If the remote controller does not operate smoothly,
replace both the batteries at the same time.
• The life of the batteries supplied is about six months but this will
vary depending on usage.
3 2 1
RC -447 M
30˚
30˚
Using the remote controller
Point the remote controller toward the remote control sensor. The
STANDBY indicator lights up when the unit receives a signal from
the remote controller.
Remote control sensor
STANDBY indicator
TX-DS595
Approx. 5 meters
(16 feet)
Notes:
• Place the unit away from strong light such as direct sunlight or
inverted fluorescent light which can prevent proper operation of
the remote controller.
• Using another remote controller of the same type in the same
room or using the unit near equipment which uses infrared rays
may cause operational interference.
• Do not put objects on the remote controller. Its buttons may be
pressed by mistake and drain the batteries.
• Make sure the audio rack doors do not have colored glass.
Placing the unit behind such doors may prevent proper remote
controller operation.
• If there is any obstacle between the remote controller and the
remote control sensor, the remote controller will not operate.