Onkyo TX-DS595 - Manual (Page 21)

21
STANDBY/ON
STANDBY
OFF ON
POWER
MASTER VOLUME
BASS TREBLE
AV RECEIVER TX-DS 595
PHONES FM AM PHONO C D TAPE
CH LEVEL
VIDEO 2 VIDEO 3 VIDEO 1 DVD
VCR
TUNING PRESET SMART SCAN NAVIGATOR PRESET MEMORY FM MODE DISPLAY RT / PTY/ TP
PUSH TO ENTER
DSP / MODE ADJ SETUP
RETURN
A B SPEAKERS
AUDIO SELECTOR
FM MODE
AM FM
TUNING /
Listening to Radio Broadcasts
One of the features of the TX-DS595 that is most frequently used is
its ability to play FM and AM broadcast radio stations. The TX-
DS595 provides a number of listening modes perfect for listening to
the radio and getting the most out of your audio system. Also, by
presetting radio stations that you listen to frequently, you can select
them easily by pressing the CH
button on the remote controller.
Tuning into a radio station
1. Press either the AM or FM input
source button.
2. Using the TUNING and buttons
on the front panel, tune into the
station you desire.
FM AM
• The tuner frequency changes in 50 kHz increments for FM
and 10 kHz (or 9kHz) increments for AM.
• When tuning into FM stations, you can press the TUNING
or button continuously for more than 0.5 seconds to scan
for an FM station in the direction of the button you pressed
(FM auto tuning mode). After you release the button and a
station is received in stereo, the scanning stops.
• The European model allows you to receive RDS broadcasts.
See pages 23 and 24 for a more detailed explanation.
TUNING TUNING
TUNED
FM STEREO
FM MUTE
Tuned in stereo
Band Frequency
FM MUTE
“FM STEREO”
(Lights red)
Listening to a stereo radio station (FM mode)
When you tune into a radio station, TUNED
indicator appears in the display. If you tune into
an FM station in stereo, then “FM STEREO”
appears. If the signal is weak, it may be
impossible to tune into the station in stereo. In
such a case, press the FM MODE button on the
front panel. The FM MUTE indicator turns off.
At this time, the station will be in mono and
interstation noise will be heard.
FM MODE