OTC Wireless 802.11 Wireless Serial Solutions WiSER2400.IP - Manual (Page 24)

WiSER 2400 Technical Manual Version 2.16 Copyright  2001-2005, OTC Wireless, Inc. All Rights Reserved Page 24 of 32
3.4.2 Serial-IP-Proxy
MAC Address: the MAC address of the WiSER2400. This field is not
modifiable.
DHCP Enable: Allows the WiSER2400 to obtain IP address from a
DHCP server.
IP Address: The IP address of the WiSER2400, user configurable.
Listen Port: The port number used by the WiSER2400 to
communicate. This is the source port number in the
TCP/UDP packets sent from this WiSER2400.
Default value: 8002.
Subnet Mask: For configuring the subnet mask settings.
Gateway: For specifying the IP address of the Gateway.
Protocol
TCP (Client): For setting the WiSER2400 as a TCP Client.
TCP (Server): For setting the WiSER2400 as a TCP Server.
UDP: For setting up the WiSER2400 to run UDP protocol:
Receive Broadcast Packet: Optional operation mode to enable the
WiSER2400 to receive UDP broadcast
packets.
Send Serial Data Broadcast:
Optional operation mode to enable the data
received from the WiSER2400 serial port to be
transmitted wirelessly as UDP broadcast
packets.
Note: The WiSER2400 can only operate in either UDP
mode or TCP mode, but not in both modes
simultaneously.
Fig. 15 WiSER2400 administration software
Configuration/Serial-IP-Proxy panel