Oricom S6000 - Manual (Page 40)

Appendix: Default Settings
External ringer melody (handset and base): MELODY 1
Internal ringer melody (handset): MELODY 2
Handset Ring Volume:
Base Ring Volume:
Receiver Volume: Med
Flash Timing: FLASH 1
Dial Mode: Tone
Auto Answer: On
Key Beep Tone: On
Confirmation Tone: On
Charging Tone: On
Backlit (if applicable): On
Call Timer: On
Message Waiting Indicator: Off
Monitor: Off
Direct Dial function: Off
Direct Dial number: Empty
Prefix Dialling: Off
Prefixes and numbers: Empty
Call Barring: Off
Call bar and exempt numbers: Empty
Operator services: Default services
Base Selection: Auto
PIN Code: 0000 (for base menu)
SMS Service: ON
Service centre numbers: Pre-programmed #
Active service centre: Service centre 1
Sub-Address: 0
SMS Alert Tone: On
Handset Name: ORICOM
Language: English
Troubleshooting
The phone does not work at all
• Make sure that adapter and phone cord are connected properly.
• Check that the batteries are fully charged and installed properly.
• Check that the handset is correctly registered to the same base
unit.
• Move the handset closer to the base unit.
The phone does not ring
• Make sure the adapter and the phone cord are connected properly.
• Move the handset closer to the base unit.
• Check that the handset is correctly registered to the same base
unit.
• Make sure the handset (or base) ringer is turned on.
The phone does not dial out
• Check that the phone cord is connected properly.
• Check the handset is fully charged.
• Check that the handset is correctly registered to the same base
unit.
• The dialled number may be barred. See Call Barring section
• The keypad may be locked. See Handset Keypad Lock/Unlock
section.
CID does not work properly
• Check with your local phone company that the CID service is
subscribed to.
• Let the phone ring at least once before answering.
The CIDCW call cannot be answered
• Check with your local phone company and select the correct recall
duration.
Base charge light does not work
• Make sure that adapter is connected properly.
• Make sure the handset is making contact in the cradle.
The empty battery icon appears soon after the batteries are charged
• Replace the batteries with new ones.
40 of 42