Onkyo HT-RC160 - Manual (Page 71)

71
Advanced Setup
—Continued
DTS Setting
Neo:6 Music
Center Image 0 to 5 (default: 2)
The DTS Neo:6 Music listening mode creates 6-channel surround sound from 2-channel stereo sources. With
this setting, you can specify by how much the front left and right channel output is attenuated in order to create
the center channel.
Setting a value [0] in the middle is set to hear a sound. Sound is spread in left and right (the outside) so that the
set value is made big. Please adjust by liking.
Audyssey Settings
When the room correction and speaker setup is complete, the “Equalizer Settings” (page 69) will be set to “Audyssey”
and the “Dynamic EQ” will be set to “On”.
Dynamic EQ
Off: Audyssey Dynamic EQ off (default).
On: Audyssey Dynamic EQ on.
With Audyssey Dynamic EQ, you can enjoy great sound even when listening at low volume levels.
Audyssey Dynamic EQ solves the problem of deteriorating sound quality as volume is decreased by taking into
account human perception and room acoustics. It does so by selecting the correct frequency response and
surround volume levels moment-by-moment so that the content sounds the way it was created at any volume
level—not just at reference level.
Dynamic Volume (see page 45)
Off: Audyssey Dynamic Volume™ off.
Light: Light Compression Mode becomes active.
Medium: Medium Compression Mode becomes active.
Heavy: Heavy Compression Mode becomes active. This setting affects volume the most,
causing all sounds to be of equal loudness.
Note:
After the room correction and speaker setup is completed, even if Equalizer Setting is set to other than “Audys-
sey”, when Dynamic EQ is set to “On”, Equalizer Settings is set to “Audyssey”.
When Dynamic Volume is set to effective, Equalizer Setting is set to “Audyssey” and Dynamic EQ is set to
“On”. When Dynamic EQ is set to “Off”, Dynamic Volume becomes “Off” automatically.
Theater-Dimensional Setting
Listening Angle Wide: Select if the listening angle is 40 degrees (default).
Narrow: Select if the listening angle is 20 degrees.
With this setting, you can optimize the Theater-Dimen-
sional listening mode by specifying the angle of the front
left and right speakers relative to the listening position.
Ideally, the front left and right speakers should be equidis-
tant from the listening position and at an angle close to
one of the two available settings.
20°/40°
Front left speaker Front right speaker