Onkyo BD-SP808 - Manual (Page 10)

10 EN
FUNCTIONAL OVERVIEW
* The unit can also be turned on by pressing these buttons.
1. I /
y y
ON/STANDBY button
• Press to turn on the unit, or to turn the unit into the
standby mode. (To completely shut down the unit,
you must unplug the AC power cord)
2. STANDBY indicator
• This indicator lights up in red when the unit is in
standby mode and turns off when the unit is active.
3. CD indicator
• This indicator lights up in green when a CD is
inserted in this unit.
4. BD indicator
• This indicator lights up in blue when a BD is inserted
in this unit.
5. DVD indicator
• This indicator lights up in orange when a DVD is
inserted in this unit.
6. Infrared sensor window
• Receive signals from your remote control so that
you can control the unit from a distance.
7. Disc tray
• Place a disc when opening the disc tray.
8. Display
• Refer to “Front Panel Display” on page 13.
9.
A (open / close) button*
• Press to open or close the disc tray.
10. SD CARD slot
• Insert an SD Memory Card, and play back the
contents in it.
11.
k
(pause) button
• Press to pause playback.
12.
C (stop) button
• Press to stop playback.
13.
B (play) button*
• Press to start or resume playback.
14.
H / G (skip down / up) buttons
• Press to skip to the previous or next title / chapter /
track / file.
1. AC INLET terminal
• Use to connect the AC outlet with the AC cord.
2. AUDIO OUTPUT (DIGITAL OPTICAL / COAXIAL) jacks
• Use to connect an AV receiver / amplifier, Dolby
Digital / DTS decoder or other device with a digital
audio optical / coaxial input jack with a digital audio
optical / coaxial cable.
3. VIDEO OUTPUT (COMPONENT) jacks
• Use to connect a TV or AV receiver with component
video inputs with an RCA component video cable.
4. VIDEO OUTPUT (VIDEO) jack
• Use to connect a TV, an AV receiver or other device
with an RCA video cable.
5. IR IN jack
• A commercially available IR receiver can be
connected to the IR IN jack, allowing you to control
the BD player when it’s out of sight, for example,
installed in a cabinet.
6. IR OUT jack
• A commercially available IR emitter can be
connected to the IR OUT jack to pass IR (infrared)
remote control signals along to other components.
7. CONTROL CONNECTOR (RS-232)
• This bidirectional RS-232 port can be connected to
an external controller.
8. AUDIO OUTPUT (ANALOG L / R) jacks
• Use to connect a TV, an AV receiver / amplifier or
other device with an RCA audio cable.
9. HDMI OUT jack
• Use to connect a TV, an AV receiver / amplifier or
other device with an HDMI compatible port with an
HDMI cable.
10. ETHERNET terminal
• Use to connect a network equipment with LAN cable.
Note
• Do not touch the inner pins of the jacks on the rear panel.
Electrostatic discharge may cause permanent damage to
the unit.
• This unit does not have the RF modulator.
BD-SP808 BD-SP808 BLU-RAY DISC PLAYER
ON / STANDBY
C D B D DVD
STANDBY
SD CARD
7 3 1 6 12 9 * 2 13 * 10 14 8 4 5 11
2 1
10
6 7 8 3 4 5
9
Front Panel
Rear Panel