SUUNTO Stinger User Manual

Page 78

3. Press S to change the selection in the following

sequence.
-> On/OFF status -> depth alarm limit -> dive time

alarm minutes (-> dive time alarm seconds)
4. While the alarm status [On/OFF] is selected

(blinking), press + or - to change the status. When the

alarm status is On, the depth alarm indicator ( -

symbol) in the bottom right corner of the display

indicates that the alarm is on.
5. While the depth digits are selected (blinking), press

+ to increase the value or - to decrease it at intervals of

0.5 m [1 ft]. Holding down either button starts the

scrolling of the depth value. The range of the depth is

from 3.0 to 150 m [10 to 450 ft]. The default setting is

40m [131ft]. If set to 0, the alarm is disabled.
6. While the dive time minutes are selected (blinking),

press + or - to change the time. If the time is less than

five (5) minutes, the dive time alarm seconds can also

be set. This feature can be used for freediving (Fig.

4.13.)
7. After you have set the depth alarm, press the M button

to save the settings and to return to the Setting Mode

[SET].

Fig. 4.16. Setting Altitude

Adjustment.

Fig. 4.15. Adjustment Mode.