Water contacts – SUUNTO Stinger User Manual

Page 20

To select the display in the Logbook Mode press the select button.

To select the dive planning mode in the dive surface modes.

To make a special bookmark in the profile memory during a dive and to

operate the timer in the Gauge mode.

+, -

To show the date, seconds or dual time in the time keeping display press

the + or - button.

In the Setting Mode
to increase the value press the + button
to decrease the value press the - button.

To operate the stopwatch see chapter 2.4.2.

To select the dive in the Logbook Mode
press the + button to move forward
press the - button to move backwards.

2.3. WATER CONTACTS

The water contact is located on the right side of the case (Fig. 2.2.). When submerged

the contact is connected to the case by the conductivity of the water and the Surface

or Diving Mode is automatically activated.
Contamination or dirt on the water contact may prevent this automatic operation. It

is, therefore, important that the water contact is kept clean. The contact can be cleaned

with fresh water and a soft brush (e.g. tooth brush).