Onkyo HT-S990THX - Manual (Page 55)

55
Advanced Setup —Continued
Speaker Configuration
These settings are used to specify which speakers are
connected.
1 Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
2 Use the Up and Down [ ]/[ ]
buttons to select “2. SP Config,”
and then press the [ENTER] but-
ton.
3 While the Subwoofer setting is
selected, use the Left and Right
[
]/[ ] buttons to select Yes or
No .
Yes: Select if a subwoofer is con-
nected.
No: Select if no subwoofer is con-
nected.
4 Use the Down [ ] button to
select “Center,” and then use the
Left and Right [
]/[ ] buttons to
select Yes or No .
Yes: Select if the center speaker is
connected.
No: Select if no center speaker is
connected.
Speaker Configuration settings only need to
be changed if you’re not using the speakers in
this package.
These settings cannot be changed while head-
phones are connected, speaker set B is on, or
the multichannel DVD input is being used.
RECEIVER
SETUP
5 Use the Down [ ] button to
select “Surround,” and then use
the Left and Right [
]/[ ] but-
tons to select Yes or No .
Yes: Select if the surround speak-
ers are connected.
No: Select if no surround speakers
are connected.
6 Use the Down [ ] button to
select “Surr Back,” and use the
Left and Right [
]/[ ] buttons to
select Yes or No .
Yes: Select if the surround back
speakers are connected.
No: Select if no surround back
speakers are connected.
7 Use the Down [ ] button to
select “SurrBack ch,” and use the
Left and Right [
]/[ ] buttons to
select 2ch or 1ch .
2ch: Select if two (left and right)
surround back speakers are
connected.
1ch: Select if one surround back
speaker is connected.
Note:
• If the Surround and Surr Back set-
tings in steps 5 and 6 are set to No,
this setting does not appear.
8 Press the [SETUP] button.
Setup closes.
SETUP