Orion Car Audio XTREME 600.4 - Manual (Page 42)

page 42
probable that the component has inadequate isolation. Solutions include, changing components or permanently adding an
external isolated power supply (Call Autosound 2000 at 209-465-3450 for info on isolated power supplies).
SUMMATION
During the design stage of your vehicles, try to avoid using extra batteries and high output alternators. Extra batteries are
nothing but loads as soon as the engine is started and high output alternators usually make more noise than stock alterna-
tors. Also, extra batteries installed in the trunk of a car will ALWAYS force extra ripple current to flow over the car.
Install Transient Storage as close to the power supply input of your amplifier as possible. The big caps will feed the switching
power supplies of your amps and minimize the inductive losses in your power wiring. Plus, they will help your peak system
response.
In problem cases, we highly recommend the use of twisted pair cable rather than coaxial cable for RCA leads. This practice
will greatly minimize cable induced noise - especially in four channel amps!
Don’t forget that your system is only as good as its worst component. Do NOT use components with inadequate power supply
isolation or you will be asking for problems.
The best electrical ground on a car is the CHASSIS of the car. Do NOT run ground leads up to th
e case of the alternator or the negative battery post. Keep ALL ground leads as short as possible.
With properly isolated components, it does NOT matter where the component is grounded. With inadequately isolated
components, it matters! With poorly isolated components, different grounds can cause different noises.
The deck is the signal reference ground for the entire sound system. The deck usually has THREE connections to the car’s
chassis: The black ground lead, the base of the antenna, and the metal-to-metal bond between the case of the deck and the
chassis of the car. With three grounds, there is usually NO cause to worry about the ground of a deck.
Amplifiers are usually designed with adequate power supply isolation. This means that it should not matter where a deck is
grounded. (Decks are grounded three times and amps float. This is car audio!)