Orion Car Audio XTREME 600.4 - Manual (Page 15)

System 3 is a three-way tri-amplified system. Amplifier 1 is bi-amplified for the front separates. Amplifier 2 is configured for two-way operation.
The front channels are configured for two 4-ohm subwoofers. The rear channels are configured for rear satellites. The RGC-1 controls the subwoofer
level from the dashboard of the vehicle.
Amplifier 1
•
Lowest recommended impedance is 2 ohms stereo operation
• Front channels are configured for stereo operation
•
Front channels are configured for bandpass operation
•
Rear channels are configured for stereo operation
• Rear channels are configured for high-pass operation
Amplifier 2
•
Lowest recommended impedance in 2 ohms stereo
•
Front channels configured for summed stereo operation
• Front channels configured for low-pass operation with INTELLiQ.
• Rear channels are configured for stereo operation
•
Rear channel input configured for high-pass operation
• RGC –1 connected to front gain point controls bass level for the system.
Note: INTELLiQ is a trademark feature of ORION amplifiers that maximize the performance of any subwoofer system for information regarding the
setup of INTELLiQ please refer to the crossover section of this manual that explains INTELLiQ.
SYSTEM PLANNING SYSTEM 3
page 15