Onkyo DV-SP302 - Manual (Page 34)

34
Troubleshooting
Remote Controller
Symptoms Causes Remedies Pages
The buttons on the DVD
Player operate but the
buttons on the remote
controller do not operate. • No batteries are inserted in the remote
controller.
• The batteries are worn out.
• The remote controller is not pointed at the
remote sensor of the DVD Player.
• The remote controller is too far from the
DVD Player.
• Insert new batteries.
• Replace with new batteries.
• Point the remote controller at the remote sensor of
the DVD Player.
• Operate the remote controller within 5 m (16
feet).
13
13
13
13
Because the unit contains a microcomputer to provide advanced functions, it may malfunction due to external noise or static electricity.
If this happens, press the POWER switch on the unit and then press it again after about five seconds.
In case you forgot the password
Set the initial setup to the factory setup with the following procedure.
1. Press Open/Close
0 to open the disc tray.
2. Press and hold 1 button on the DV-SP302 more than 3 seconds.
3. While holding 1 button, press STANDBY/ON button on the remote controller simultaneously.
4. Press POWER to switch off the main power.
Onkyo is not responsible for damages (such as CD rental fees) due to unsuccessful recordings caused by the unit’s malfunction. Before
you record important data, make sure that the material will be recorded correctly.