System accessories, Ps2ac breaker panel, Ps2dc breaker panel – Outback Power Systems Systems User Manual

Page 16

OutBack Power Systems Inc.

2005

System Accessories

PS2

OutBack Power oﬀ ers compact enclosures for all of the

AC and DC components of a renewable energy power

conversion system. Th e PS2 series saves time, money

and space by combining the disconnects, over-current

protection devices and control components into easy-

to-install enclosures. Capable of supporting one or two OutBack FX series inverter/chargers, up to three MX60 charge

controllers, a MATE system controller and all the associated AC and DC components.

Th e OutBack PS2 series can be fully customized to your application and ordered pre-wired or as individual

components for ﬁ eld assembly.

PS2AC Breaker Panel

Th e PS2AC is engineered to be a code-compliant steel enclosure for AC power
routing and management.

• ETL listed indoor type powder coated enclosure

• Ground terminal bus bar bonded to cabinet

• One white insulated AC neutral terminal bus bar

• Two black insulated bus bars for Hot AC IN and OUT Leg 1

• Two red insulated bus bars for Hot AC IN and OUT Leg 2

• Knockouts for eight additional OutBack AC load breakers

• Provisions for mounting an X-240 and cooling fan

• Knockouts on ﬁ ve surfaces to facilitate conduit and inverter connections

Shown with 120/240 VAC/60 Hz dual inverter bypass (50D) or 230 VAC/50 Hz dual

inverter bypass (50DE) and additional AC load breakers

PS2DC Breaker Panel

Th e PS2DC is a code-compliant steel enclosure engineered to contain all DC power
routing and management components.

• ETL listed indoor type powder coated enclosure with plenty of conduit knockouts

• Knockouts for one additional inverter battery breaker and eight 3/4" (19 mm)

breakers

• 500 amp 50 mVolts DC current shunt standard

• Battery negative/ground bus bar standard

• Battery positive bus bar for DC loads and PV arrays included standard

• Knockouts for battery conduit, MX60 interconnect and stacking another PS2DC

• Use for negative or positive ground systems

• Knockouts on ﬁ ve surfaces to facilitate conduit - inverter connections and

additional MX60s

Shown with DC breakers and DC-GFP/2 - order separately