Onkyo HT-S4100 - Manual (Page 39)

39
First Time Setup —Continued
5 Use the Down [ ] button to
select “Center,” and then use the
Left and Right [
]/[ ] buttons to
select Small , Large , or None .
Small: Select if the center speaker is
small.
Large: Select if the center speaker is
large.
None: Select if no center speaker is
connected.
Note:
• If the Front setting in step 4 is set to
Small, the Large option cannot be
selected.
6 Use the Down [ ] button to
select “Surround,” and then use
the Left and Right [
]/[ ] but-
tons to select Small , Large , or
None .
Small: Select if the surround speak-
ers are small.
Large: Select if the surround speak-
ers are large.
None: Select if no surround speakers
are connected.
Note:
• If the Front setting in step 4 is set to
Small, the Large option cannot be
selected.
7 Press the [SETUP] button.
Setup closes.
When you want to go back up one
menu level to “SP Config,” press the
[RETURN] button.
SETUP
Testing the speakers
To test that all of the speakers are working properly,
press the remote controller’s [TEST TONE] but-
ton.
The test tone will be output by each speaker in turn
and the name of each speaker will appear on the dis-
play. To turn off the test tone, press the [TEST
TONE] button again.
• If the test tone is not produced by a speaker, or it’s
produced by a speaker other than that shown on
the display, you may have wired the speakers
incorrectly and you should check your connec-
tions (see pages 21, 22).
• If the test tone is not produced by a speaker and its
name does not appear on the display, you may
have set the speaker settings incorrectly (see
page 38).
RANDOM SUBTITLE
PLAY MODE
AUDIO REPEAT
RC- 645S
LISTENING MODE
DISPLAY
TEST TONE CH SEL
SURROUND STEREO
CINE FLTR
LEVEL+ LEVEL-
L NIGHT
TEST TONE