Onkyo HT-S4100 - Manual (Page 22)

22
Connecting Your Speakers —Continued
Using a suitable cable, connect the AV receiver’s SUB-
WOOFER PRE OUT to an input on your powered sub-
woofer, as shown.
Note:
Make sure the cable is plugged all the way.
The following illustration shows which speaker should be connected to each pair of terminals.
Connecting Speaker
1 Strip 3/8" (10 mm) of insu-
lation from the ends of the
speaker cables, and twist
the bare wires tightly, as
shown.
2 While pressing the lever, insert
the wire into the hole, and then
release the lever.
Make sure that the terminals are
gripping the bare wires, not the
insulation.
3/8" (10 mm)
Connecting a Powered Subwoofer
LINE INPUT
LINE INPUT
Powered
subwoofer
Front left
speaker
Front right
speaker
Center speaker
Surround
right
speaker
Surround
left
speaker
Speaker Set A
Front left
speaker
Front right
speaker
Speaker Set B