Omega Engineering RD260A - Manual (Page 17)

2-7
2
Daily Operation
Replacement under pen-replacement mode
When a pen is located at a place where its replacement is difficult to do, relocate the pen
by the following procedures:
1. Make sure that recording is OFF. The main Power switch must be ON.
2. Press the key for three seconds to display [C_Pen], and press the ENT key.
3. Press the key to display [Yes], and press the ENT key. The pens will move near to
the center of the scale where the pens can be easily replaced.
Note that a line is drawn on the chart when the pens move.
4. Replace the pen according to the ‘simple replacement’ 2, 3, and 4 described above.
5. After pen replacement the indicator shows [End], then press the ENT key.
6. To restart recording, press the RCD key.
Installing/Replacing Pens (Pen Model)