1 recording – Omega Engineering RD260A User Manual

Page 11

2-1

Daily Operation

2.1

Recording

Switching Power ON/OFF

The power switch is located at the lower right-hand corner of the front face behind the

door. The switch is a push-button type. Press the switch to turn the recorder ON and

press again to turn it OFF.

After the power turns ON, the recorder executes a self-diagnostic check for several

seconds before starting measurement and recording.

OFF

Power Switch

Note

• The warm-up time is approximately 30 minutes; however, after the initial start-up, the recorder

might need more time.

• If the input wiring is connected parallel with other equipment, do not turn the power switch ON/

OFF to prevent fluctuations in measuring values.

Starting/Stopping Recording

Press the RCD key to start or stop the recording.

Feeding Chart Paper

The chart paper is fed by pressing the FEED key as long as the key is pressed.