Omega Engineering RD260A - Manual (Page 16)

2-6
2.5 Installing/Replacing Pens (Pen Model)
CAUTION
• Do not press or pinch the felt tip to prevent deformation. Do not move the pen
holder up- or down-scale to protect the driving mechanism.
• Always make sure to remove the pen cap before installation.
Simple replacement
1. Open the front door, and make sure that recording is OFF. Power may be ON.
2. Pull and open the display around the hinge.
CAUTION
• Please take care not to apply any undue pressure in an upward or downward
direction to the display, to prevent strain on the hinges.
• Do not force the display open any further than about 100° from being closed.
3. Pull out the pen-cartridge by pulling the protruding part of the cartridge from the pen
holder.
Pen holder
1st pen : red
2nd pen : green
3rd pen
: blue
Felt pen
4. Remove the cap from a new felt-tip pen, and insert the pen firmly to the pen holder.
5. Press the RCD key to restart the recording.