Onkyo HT S5100 - Manual (Page 79)

79
Advanced Setup —Continued
Double Bass
With the Double Bass function, you can boost bass out-
put by feeding bass sounds from the front left, right, and
center channels to the subwoofer. This function can be
set only if the Subwoofer setting (step 3) is set to Yes,
and the Front setting (step 4) is set to Large in the
Speaker Configuration on page 77.
Note:
• These settings cannot be changed while headphones
are connected, speaker set B is on, or the multichannel
DVD input is being used.
Speaker Distance
With these settings, you can specify the distance from
each speaker to the listening position.
Notes:
• The Center and Subwoofer distances can be set up to
5 ft. (1.5 m) more or less than the Left distance. For
example, if the Left distance is set to 20 ft. (6 m), the
Center and Subwoofer distances can be set between 15
and 25 ft. (4.5 and 7.5 m).
• The Surround and Surround Back distances can be set
up to 5 ft. (1.5 m) more or 15 ft. (4.5 m) less than the
Left distance. For example, if the Left distance is set
to 20 ft. (6 m), the SurrRight, Surr Left, Surr Back R,
and Surr Back L distances can be set between 5 and 25
ft. (1.5 and 7.5 m).
• The speaker distance cannot be adjusted while a pair
of headphones is connected or the multichannel DVD
input is being used.
10 Use the Down [ ] button to
select “Double Bass (D.Bass),”
and then use the Left and Right
[
]/[ ] buttons to select:
On: Double Bass function on.
Bass from the front left and
right channels is also fed to
the subwoofer (default).
Off: Double Bass function off.
11 Press the [SETUP] button.
Setup closes.
1 Measure and make a note of the
distance from each speaker to
the listening position.
2 Press the [RECEIVER] REMOTE
MODE button, followed by the
[SETUP] button.
This setting is not set automatically by the Automatic
Speaker Setup function (see page 42).
These settings are set automatically by the Automatic
Speaker Setup function (see page 42).
3 Use the Up and Down [ ]/[ ]
buttons to select “Sp Distance,”
and then press [ENTER].
4 While “Unit” is displayed, use the
Left and Right [
]/[ ] buttons to
select “feet” or “meters”.
feet: Distances can be set in feet.
Range: 1 to 30 feet in 1-foot
steps.
meters: Distances can be set in
meters. Range: 0.3 to 9
meters in 0.3-meter steps.
5 Use the Down [ ] button to
select “Front” and use the Left
and Right [
]/[ ] buttons to
specify the distance for the front
speakers, then press the Down
[
] button to select the next
speaker.
6 Repeat step 5 for all speakers.
Note:
Speakers that you set to No or None in
the Speaker Configuration (page 77)
cannot be selected.
7 Press the [SETUP] button.
Setup closes.