Omron Healthcare AUTOMATIC DIGITAL BLOOD PRESSURE MONITOR HEM-703CP - Manual (Page 5)

4
Preparations for Use
2 How to Set Time and Date 3 Plug in and Turn on
1 . When batteries are installed, the display
shows PM 12:00 .
1 . Insert the air plug into the air jack on the
left side of the main unit correctly .
2 . When the SPHYG/CLOCK button is
changed to the sphygmomanometer mode,
all the LCD symbols are momentarily
displayed . This happens because the unit
is running a check on the display and this
state lasts for approximately one second .
3 . Once the LCD symbols vanish, the air
release indication symbol (  ) starts
flashing . Please wait until the (  ) symbol
goes out .
4 . When the preparations necessary before
measurement have been completed, the
unit emits a series of beeps and finally the
“Ready to Measure” symbol ( ♥ ) will be
displayed .
2 . When the MODE button is pressed
down, the “month” sign is displayed .
When the SET button is pressed down,
the figure for the month increases . Adjust
the “month” .
3 . When the MODE button is pressed
down after the “month” has been adjusted,
the “day” sign is displayed . Adjust the
“day” in the same way as the “month” .
4 . In the same manner select the “hour” and
“min .” with the MODE button and set
each value with the SET button . AM and
PM signs are switched in accordance with
the “hour” adjsutment .
5 . Press the MODE button for the last time
and return the screen to normal time (hour,
min .) display .
Initial Display
“Ready to Measure”
Display
Air release
indication symbol