Oster 128263 - Manual (Page 7)

Cleaning Your Countertop Oven
Step 1. Turn all knobs to off position then unplug unit and let it cool.
Step 2. Wipe unit down with damp cloth. *DO NOT IMMERSE IN WATER.
Make sure to only use mild, soapy water. Abrasive cleaners, scrubbing brushes
and chemical cleaners will damage the continuous clean coating on this unit.
Step 3. Remove crumb tray by pulling out of Countertop Oven.
Step 4. Shake off crumbs from crumb tray. Cleaning the crumb tray often will
avoid any accumulations.
Step 5. Remove wire rack and clean with damp cloth or place in
top rack of dishwasher.
Storing Your Countertop Oven
Allow the appliance to cool completely before storing. If storing the Countertop Oven
for long periods of time make certain that the Countertop Oven is clean and free of food
particles. Store the Countertop Oven in a dry location such as on a table or countertop
or cupboard shelf. Wind the electrical cord around the cord storage brackets. Other than
the recommended cleaning, no further user maintenance should be necessary.
H
eLpfUL
T
ips
/ T
roUbLesHooTinG
P
roblem
• Overcooked /
Undercooked Foods
• Burnt Smell
• Oven does not
turn ON
• Only one heating
element is heating up
• Heating elements
do not stay ON
S
olution
• You may have to adjust the time
and temperature to desired taste.
• Because your Countertop Oven is smaller than
your regular oven, it will heat up faster and
generally cook in shorter periods of time.
• Refer to “Positioning Rack” Section, Page 4.
• Refer to “Cleaning Your Countertop Oven”
Section, Page 7.
• Plug the Countertop Oven into a 120-volt AC
electrical outlet.
• Set timer knob and temperature knob to desired
setting. Both must be turned on to operate the
Countertop Oven.
• Check to see if Broil setting is selected
• Confirm function setting is the correct one
of choice.
P
otential
C
auSe
• Incorrect temperature or
time setting
• Rack placement
• Food build-up inside oven,
on heating elements or in
crumb tray.
• Unit is unplugged
• Timer was not turned
past 20 minute mark.
• Function setting selection
determines which heating
element will operate.
• Heating elements will cycle
ON and OFF to maintain
proper heat.
7