Optoma Single Chip DLP Projector - Manual (Page 18)

18
E
nglish
User Controls
Image-I
(Computer mode)
Audio Image-I Image-II
Language Management
Brightness
Contrast
Color Temp.
Zoom
Keystone
Computer mode
White Segment
Low High
Brightness
Adjusting the brightness of the image.
4 Press the to darken image.
4 Press the to lighten the image.
Contrast
The contrast controls the degree of difference between the lightest
and darkest parts of the picture. Adjusting the contrast changes
the amount of black and white in the image.
4 Press the to decrease the contrast.
4 Press the to increase the contrast.
Color Temperature
Adjust the color temperature. The range is from “0” to “3”. The
factory default is “2”. With the higher temperature, the screen
looks colder; with the lower temperature, the screen looks warmer.
Zoom
4 Press the to Magnify an image up to a factor of 32 times on
the projection screen.
4 Press the to Diminish the zoom in image.
Keystone (Keystone Correction)
Adjust image distortion caused by tilting projection. (±16 degrees)
White Segment
Use the white segment control to set the white peaking level of
DMD chip. 0 stands for minimal peaking, and 10 stands for
maximum peaking. If you prefera stronger image, adjust toward
the minimum setting. For a smooth and more natural image, adjust
toward the minimum setting.
PIP