Optoma Single Chip DLP Projector - Manual (Page 11)

11
E
nglish
Installation
Powering Off the Projector
1. Press the “Power/Standby” button to turn off the projector
lamp.
2. After pressing the “Power/Standby” button, you will see a
message “Power off the lamp?” on the on-screen display.
Press the “Power/Standby” button again to confirm. Other
wise the message will disappear after 5 seconds.
3. “Power/Standby” indicator flashes red for about 2 minutes.
The projector will automatically shut itself down.
If you want to turn on the projector, you must press the
“Power/Standby”button within 2 minutes of the start of the
indicator flashing.
4. Disconnect the power cord from the electrical outlet and the
projector.
5. Do not turn on the projector immediately following a power
off procedure.
v When the “TEMP” indicator flashes red for about 10 seconds, you
will see a message “Fan Fail” on the on-screen display. After 5
seconds, the “Power/Standby” indicator flashes green for about 2
minutes and the projector will automatically shut itself down.
Please contact your local reseller or service center.
v When the “TEMP” indicator lights solid red for about 10 seconds,
it indicates the projector has been overheated. You will see a
message “Over Temperature” on the on-screen display. After 5
seconds, the “Power/Standby” indicator flashes green for about 2
minutes and the projector will automatically shut itself down.
Please contact your local reseller or service center.
v When the “LAMP” indicator lights solid orange and “Power/
Standby” indicator flashes green for about 2 minutes. The projec-
tor will automatically shut itself down. Please contact your local
reseller or service center.