Onkyo DV SP504 - Manual (Page 26)

26
Connecting the Power/Turning on the DVD player
Before connecting
• Make sure that all the connections on pages 18–25 are
complete (the connection to a TV is required).
Note:
• This player features a screen saver and an auto power
off function. If the player is stopped and no button is
pressed for 15 minutes, the screen saver starts (see
page 52). If the disc tray is closed but no disc is play-
ing and no control is pressed for 20 minutes, the player
automatically goes into standby (see page 54). 1 Plug the supplied power cord into
the AC INLET and then into the
power outlet on the wall.
• Do not use a power cord other than the
one supplied with the DVD player. The
power cord supplied is designed for
use with the DVD player and should
not be used with any other device.
• Never have the power cord discon-
nected from the DVD player while the
other end is plugged into the wall out-
let. Doing so may cause an electric
shock. Always connect by plugging
into the wall outlet last and disconnect
by unplugging from the wall outlet
first.
RETURN SETUP
TOP MENU MENU CU RSOR
PU SH TO ENTE R
STANDBY/ON
ON STANDBY
STANDBY indicator
• Before unplugging the player from the
power outlet, make sure you first
switch it into standby.
• For the above reasons, do not plug this
player into a switched power supply
found on some amplifiers and AV
receivers.
2 Press [STANDBY/ON] button on
the DVD player or [ON] on the
remote controller.
Turn on your TV and select the
input through which the DVD
player is connected.
The DVD player turns on and the
STANDBY indicator turns off.
• To put the DVD player in the standby
mode, press [STANDBY/ON] on the
DVD player, or [STANDBY] on the
remote controller.
• While the STANDBY indicator lights
up, the DVD player can receive signals
from the remote controller.
• Setting the [STANDBY/ON] button to
standby does not shut off the power
completely.
To a wall
outlet
ANDBY ST
STANDBY/ON
Remote
controller