Oricom pro600 DECT - Manual (Page 28)

26
Using Remote Access (Pro800 Only)
Remote Access (Pro800 Only)
You can call your answering machine from any
Touchtone
TM phone or mobile phone whilst you are away
from home to listen to your messages.
PIN Code for remote access
A 3-digit PIN code is required for remote access to
your answering machine. The default code is "000" but
for security reasons you should change this to a code
personal to you.
Changing the PIN code
2 sec PINCODE Announces the current security code
(Under base) and prompts for 1st digit
Select the 1st digit
Confirm the digit
Select the 2nd digit
Confirm the digit
Select the 3rd digit
Confirm the digit. Your new security code
will be announced.
Press the key at any time to exit from changing
the PIN code and return to standby. The PIN code will
then remain unchanged.
Call in to check your messages
Dial your own phone number and wait
until the answering machine picks up
the call.
2 x, , Switch to remote access and enter your
3 digit PIN code after the voice prompt.
If you enter your PIN code incorrectly, the answering
machine will hang up the call.
If you enter your PIN code correctly you can now remotely
control your answering machine by using the digits on the
keypad.
Pro_600_800.indd 26 2008-11-11 16:17:43