Oricom pro600 DECT - Manual (Page 25)

23
Using the Answering Machine (Pro800 Only)
Answering Machine (Pro800 Only)
Your answering machine can be ready for use within a
few seconds of plugging in the telephone line cord and
switching on the mains power.
Just follow the steps in this section to set up and use
your answering machine.
Switch on/off
Switches the answering machine on
or off. The current answer mode is
announced.
Set the answer mode
Switch the answering machine on
2 sec To change the mode between "Answer &
Rec." and "Answer Only"
Record your outgoing message (OGM)
Your answering machine comes with a default outgoing
message but you can record your own personal OGM of
up to 2 minutes long.
2 sec Record your message after the beep
Press to end your recording
Check your OGM
The current OGM is announced
To return to the factory pre-set OGM, just press the
key whilst the current OGM is playing.
Set the answer delay
2 sec (Under base) Enters ring delay mode and announces
the current setting.
Select between 2-9 rings or "Time
Saver".
Confirm the number or rings (2-9) or
"Time Saver".
Time saver: This feature can save you the cost of a
call when you ring in to listen to your messages from
another phone. If your answering machine answers
after 2 rings you have new messages, if it answers
after 5 rings then there are no new messages. Hang
up after the 2nd ring and you will not be charged for
the call.
Pro_600_800.indd 23 2008-11-11 16:17:41