Onkyo TX-NR808 - Manual (Page 81)

81
En
8
When you have a network connection, select
the brand name again, and then press
ENTER.
When you do NOT have a network connection,
use / to select the brand name, and then
press
ENTER.
The following screen appears.
9
The AV receiver accesses and searches the
database. Select “Search by model number( via
network )”, and then press
ENTER. When you
do NOT have a network connection, select
“Skip” when you don’t want to select the
model, and then press
ENTER.
If you select “Skip”, you will go to step 11.
10
Enter the model in a similar manner as in the
case of the brand name (step 6).
Tip
• After entering the 3rd character, press ENTER to start
searching.
• You cannot enter a space character.
11
Use / to select the model, and then press
ENTER.
If the brand name is not found, use to select
“Not Listed”, and then press ENTER .
After searching is completed, a message for
remote control code transfer will appear.
12
While pointing the remote controller at the AV
receiver’s remote control sensor, press
ENTER.
8–1. Remote Mode Setup TV
Skip
Search by model number( via network )
Category
Brand
Model TV
Sonic
(Option)
8–1. Remote Mode Setup TV
OK
Now we are ready to transfer data to remote.
Please hold remote so that it is facing the receiver.
Ready?
Category
Brand
Model TV
XXXXX
xxxxx[***/***]
15
15
Approx.
16ft. (5 m)
Incoming sensor
Remote control sensor (Transmitter)
15° off center
(Left/Right/Up/Down)
13
When you have a network connection, a mes-
sage “Successful” will appear. Now the transfer
is successful!
You’ll return to the category selection menu.
Press SETUP to end the remote mode setup.
When you do NOT have a network connection,
the following screen appears.
Push any key (except for arrow buttons and
ENTER) to see if the component responds.
* When category other than TV have been selected,
the content is different.
14
If you can control component, press
RECEIVER, use / to select “Works”, and
then press
ENTER.
If you cannot control component, use / to
select “Doesn’t work (Try next code)” and
press
ENTER.
The next code appears.
15
Press ENTER to transfer the determined code.
16
Press ENTER.
You’ll return to the category selection menu.
Press SETUP to end the remote mode setup.
8–1. Remote Mode Setup TV
Works
Doesn’t work (Try next code)
1. Push some key to see if the TV responds.
(except Arrow and Enter.)
2. Choose “Works” or “Doesn’t work”.
Category
Brand
Code TV
XXXXX
xxxxx[***/***]
*
8–1. Remote Mode Setup TV
OK
Now we are ready to transfer data to the remote.
Please hold the remote so that it is facing the receiver.
Use ENTER button of your remote to activate “OK”.
Ready?
Category
Brand
Code TV
XXXXX
xxxxx[***/***]
15
15
Approx.
16ft. (5 m)
Incoming sensor
Remote control sensor (Transmitter)
15° off center
(Left/Right/Up/Down)